Looking For Wood Folding Rule ? We Have Done the Hard Work For You!
 |
 STANLEY TOOLS BEDROCK Metal Plane Catalog Reprint  US $7.99
|
 Excellent LS STARRETT 6 foot Folding Rule Wood Brass Folding Ruler US $16.66
|
 Folding Craftsman Extension Rule 3931 NR US $5.99
|
Find More Wood Folding Rule Below. Scroll Down Now!
|
|
STANLEY TOOLS BEDROCK Metal Plane Catalog Reprint US $7.99
|
Excellent LS STARRETT 6 foot Folding Rule Wood Brass Folding Ruler US $16.66
|
Folding Craftsman Extension Rule 3931 NR US $5.99
|
 Unmarked Vintage Wood Shoe Size Measuring Rule US $35.00
|
 Rare Vintage Stanley Rule Number 94 Made in the USA Carriagemakers Rule US $125.00
|
 C BURDETT NEW YORK Wood Shoe Size Measuring Rule US $45.00
|
 Vintage Stanley Folding Rule Caliper US $16.95
|
 1961 EasiBild Pattern Catalog woodwork Pleasantville NY US $9.99
|
 VINTAGE STANLEY 84 FOLDING WOOD RULER WITH BRASS TRIM BOXWOOD US $24.99
|
 RABONE 1161 1 METER VINTAGE WOOD FOLDING RULE US $14.95
|
 tique CRAFTSMAN 3931 EXTENSION WOOD BRASS Folding RULER US $17.95
|
 STANLEY 68A FOLDING RULER 24 long with hinged sections VINTAGE US $14.99
|
 UNUSUAL VINTAGE 1 METRE WOOD BRASS RULE No 1173229 US $14.22
|
 NICE VINTAGE TWO AXE BRAND 36 FOLDING RULEPRISTINE No 8012 US $15.00
|
 ADVERTISING FOLDING RULE VINTAGE US $9.99
|
Are there general rules as to when to use nails or screws?
I built a small stand to hold a folded up stroller. I made it using pine wood and nails. It works fine, but isn't entirely sturdy. I'm rebuilding it (with a better design) with screws to make it more stable. That got me to thinking, are there general rules as to when to use nails vs screws for wordworking?
So if screws are so much stronger, why are nails used in building houses, where stability is extremely important? Is it cost issue? Time issue?
There's no hard and fast rule when it comes to small projects. These are some of the things I do, with each fastener.
Nails: Framing, trim, underlayment (ring shank nails or staples), hanging small decorations on a wall.
Screws: Installing cabinets, deck boards, drywall, some small projects, cement board under tile.
For woodworking, I seldom use screws. I usually use finish nails (in a gun, of course) or biscuits, both with wood glue. This makes for an incredibly strong joint. I don't bother with Gorilla Glue either, just basic carpenters wood glue. It's a lot cheaper, and does practically the same thing. If you have any questions, feel free to e-mail me. Good luck.
EDIT: Screws are NOT stronger. A 16D sinker nail, which is the size used for framing your house, has a shear strength of 300 lbs. Nails go in much faster, since just about all contractors use nail guns when framing (when trimming too). The threads resist pulling out of the wood, but ring shank nails will hold tightly as well. Joist hanger nails have an even greater shear strength and resistance to pull out. It all comes down to using the correct fastener for the job at hand. Screws have their place, as do nails. Feel free to e-mail me if you have any questions.